Midpipe length question

Discussions relating to Turbochargers, Superchargers, Induction, Engine Mods, Exhaust Mods, and other items specifically to make your MX5 or Roadster put out more power.

Moderators: Growler, jif, SLYDIT, Born_disturbed

Post Reply
authentic
I have stars and not afraid to use them
I have stars and not afraid to use them
Posts: 277
Joined: Wed Jun 06, 2012 8:45 pm
Location: Wellington

Midpipe length question

Post by authentic » Fri Jan 04, 2013 3:18 pm

I have some stainless headers on the way, and I have a 'cat-back' stainless system currently installed with stock headers and a rough straight pipe replacing the cat which I want to replace with a stainless steel 'test pipe'. However, the straight piece that I have in place seems like it is quite long compared to the photos of stainless test pipes/replacement cats I've seen.

A bit of the stock headers has been cut off as you can see so maybe that is throwing my judgement off, but is my current midpipe the same length compared to other aftermarket pieces, i.e. does the flange sit at the same place that others do?

Image

Image

Image

Image

Post Reply

Return to “MX5 Power & Power Mods”

Who is online

Users browsing this forum: No registered users and 13 guests