Hmmm!!!Yep! point taken, also if it was 316 stainless, or even a lump of bog (heaven
forbid), would cause the same problem, but i must add you dont know its a stone yet,
you could always attach a grease nipple and fill it with grease, but seriously Glen
if you want to use a hole cutter, start with a 12mm right underneath at the bottom
out of imediate sight some where near where the sound is then use a gas welding rod
and fish for it, you might be able to see it to know how big and what it is, you
could then use a rubber bung to plug the hole again! not the best way but could stop
you going mad eh!
good luck
Ray
interesting point on the 626 relays eh? any idea what year 626?
[...]
attn Glen
Who is online
Users browsing this forum: No registered users and 80 guests