Hi All,
I am in the process of rebuilding a replacement cylinder head for my engine
(1990 1.6L).
Just found out the locating dowel pin for the cam gear on the inlet camshaft
has been snapped off.
Does anyone have a spare inlet cam for a 1.6 they want to sell?
Regards,
Anthony.
1990 NA 1.6 Inlet Camshaft
1990 NA 1.6 Inlet Camshaft
if you're in Auckland, City Garage has a spare head sitting around at the
moment...
moment...
-
- Need, more, 5-ing, time....
- Posts: 113
- Joined: Fri May 19, 2006 10:05 am
- Location: Manukau, NZ
1990 NA 1.6 Inlet Camshaft
Thanks Jeff, will give them a call on Monday.
-
- Yes. I might just know (Trusted Advisor)
- Posts: 119
- Joined: Thu May 18, 2006 10:11 pm
- Location: Auckland
1990 NA 1.6 Inlet Camshaft
It shouldn't be that hard to just remove and replace the dowel...
its 5mm diameter, and any engineering supply can give you what you need
(about 5mm diameter and 10-15mm long), I think I payed 50c or $2 ? nearly
nothing.
You could try removal either by applying heat, and then tapping the
cam-shaft with a hammer while the offending end was facing downwards (ie.
shock/gravity)
Or, drill/tap a small hole down the middle of it and extract it with a
screw?
In any case, I think you can solve this problem for way less than the price
of a camshaft or head...
Fletch.
its 5mm diameter, and any engineering supply can give you what you need
(about 5mm diameter and 10-15mm long), I think I payed 50c or $2 ? nearly
nothing.
You could try removal either by applying heat, and then tapping the
cam-shaft with a hammer while the offending end was facing downwards (ie.
shock/gravity)
Or, drill/tap a small hole down the middle of it and extract it with a
screw?
In any case, I think you can solve this problem for way less than the price
of a camshaft or head...
Fletch.
Red '90. Many n/a mods and Link ECU
-
- Need, more, 5-ing, time....
- Posts: 113
- Joined: Fri May 19, 2006 10:05 am
- Location: Manukau, NZ
1990 NA 1.6 Inlet Camshaft
Thanks Fletch, great information, had wondered about it being removable.
Shall give it a try.
Anthony.
[...]
Shall give it a try.
Anthony.
[...]
Who is online
Users browsing this forum: No registered users and 23 guests